There are four to six SATA connections usually in a normal motherboard which allows multiple SATA hard drives to hook up. Firstly, open the external part of your computer or your computer case to get access to the motherboard and the hard drive connections. You may need a screwdriver or may not need

The wide wire in IDE cables caused airflow problems inside the case. The narrower SATA cable allows free airflow inside the case. Data transfer speed for IDE ranges from 5MB/s up to 133MB/s (ATA100/133). The parallel wire transfer mode reached its limit with the speed of 133 MB/s.

IDE To SATA Converter

It may even work with a SATA Drive but not a SSD Drive as while these days they are interchangeable in the past they where not always so. Also the hardware always treats IDE Drives as the Default Master Drive and writes the Boot Loaded to that Drive so it’s important after the Clone to remove the IDE Drive before starting the system on the SSD Drive. You will feel when you will know about it that connecting the IDE hard drive to the SATA motherboard is a very easy task. It will take at most 10-20 minutes. Remember that the computer must be unplugged from any electrical connection. IDE Hard Drive: It is one of the most elements that’s needed. You know by now what IDE is. IDE hard drives are easily identifiable through their pin connection points usually. In most of the cases, the installation is by plugging it into the required component. It is needed to ensure a tight connection.

Just my opinion though but look in the BIOS and see if there is an Option to make a SATA Drive the boot drive as that would remove the need for a Driver.

About the Author

The SATA drives usually need very little power than PATA drives. The SATA drive usually uses only 250 mV of power, which is even 25 percent of one volt. SATA took off where ATA stopped as far as speed is concerned. The first generation of SATA was 1.2 Gbit/s (150 MB/s; note that MB is mega bytes and Gb is giga bits) similar to PATA/133. Today the third generation of SATA (3.0) (released on May 27, 2009), 6 Gbit/s (600 MB/s) hard drives and motherboards are being used. But the SATA bus is a serial point-to-point bus, which means only one device can be connected on each channel. Many SATA drives can connect to the motherboard via multiple ports, and the drive to boot from is specified in the BIOS settings. SATA drives have an additional feature of Hot plugging which mean that even as the computer is running drives can be removed or added.

While it is possible to make the necessary changes if drivers are required to run that type of drive it is a lot of messing around. Also if Windows has been loaded for more that 12 months it’s better to do a Clean Install so you can get rid of all the crud that clogs up the Registry. Hard drives need a cable/connection for data and one for power. Parallel ATA only allows data cable lengths up to 18 in (457 mm) while SATA allows cable lengths up to 1 m (3.28 ft). eSATA cables can be 2 m in length.SATA has also done away with the master/slave configuration (technically, device 0 and device 1) used in IDE drives. With PATA (IDE), attaching two hard disks to the same channel required one to be set to be the master, the other the slave. For hardware, this usually meant setting the right jumper settings. The lower power consumption of SATA connection drives helps to keep the inner part of the computer case cooler and also reduces the power supply drain at a considerable range.