Electronic TRV Thermostat Valve Head (28mm to 30mm Adapter)

Product Information

As the Hive comes with an M30 adaptor, if I install your adaptor, would that allow me to connect the HIVE TRV's? If you are using the Smart Radiator Thermostats from Bosch in combination with low temperature radiators, you need to define a high set point so the valves do not close during high room temperatures.

Danfoss RA TRV Adaptor - Heating Controls Online Danfoss RA TRV Adaptor - Heating Controls Online

You'll save 10% on your Hive Radiator Valve(s) today and you can cancel Hive Heating Plus at any time. You will be able to pair the Bosch EasyControl with the EasyControl RF Key and use it in combination with our table stand. I have Honeywell Evohome motorised radiator valves, and they were supplied with adaptors which look relevant to your situation.

The Hive app uses helpful images to guide you through removing your old controls, selecting the correct adaptor for your radiator and getting your Hive Radiator Valve correctly installed. If this does not give the desired result, reset the router to factory settings to reset the values above. If the pin is stuck and the Hive Radiator Valve motor can't easily move it up and down, it cannot effectively control the heat coming from the radiator.

Honeywell Home ACH28 Thermostatic Radiator Valve Adaptor For

Honeywell Home EVA1 Danfoss Thermostatic Radiator Valve (TRV) Adapter Pack – The Honeywell Home EVA1 Danfoss is a Thermostatic Radiator Valve Adaptor Pack allows Honeywell Home Radiator Controllers to fit TRV’s with Danfoss TRV’s. When wanting to use an EasyControl with an older Worcester Bosch Combi or with another brand of heating appliance via the OpenTherm or 230v on/off connections a EasyControl adapter should be used. If you have any questions about the Honeywell EVA1 Danfoss Thermostatic Radiator Valve Adaptor Pack, please feel free toÿ Contact Us. Replacing an existing TRV (a large, cylindrical valve with a numbered dial at the bottom of your radiator) is straightforward; you just need to unscrew your existing TRV, select the right adaptor and screw a Hive Radiator Valve in its place.

Try to do a soft reset of the EasyControl and remove the batteries of the Smart TRV and put them back to solve the issue.

Adapter for Danfoss thermostatic heads, RAVL valves 24 mm

With an EasyControl Adapter, the EasyControl is also compatible with appliances that use the OpenTherm protocol and appliances with an On/Off interface (between 18-230Vac). If you are swapping your valve bodies too, we recommend installing your new Hive Radiator Valve on the flow side of the radiator. Channels 1, 6, or 11 are the best Wi-Fi channels because they do not overlap if there are multiple wireless networks. It controls the flow of hot water into an individual radiator so you can manage your heating room by room.The most common thermostatic valves (including Drayton, Honeywell, Pegler, Myson and Siemens) have an M30 x 1. The placement of the EasyControl, a new TV, microwave, computer or anything that can cause disturbances in the Radio Frequency could be a potential cause of the Smart TRV problems. i take it i need to drain the system down and then take the old adaptors out and then replace with the new ? Our app will guide you through removing your old controls, selecting the correct adaptor and getting your Hive Radiator Valves installed. The male thread on the top of the adapter is M30 (30mm) and the female thread on the bottom is M28 (28mm).