I only needed a tiny amount, so had to guess the proportions but it worked OK. I also found that I over sanded which left a depression so had to top up the filler, but that was fine. P101 If medical advice is needed, have product container or label at hand.P102 Keep out of reach of children.P210 Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking.P211 Do not spray on an open flame or other ignition source.P251 Do not pierce or burn, even after use.P410 + P412 Protect from sunlight. Do no expose to temperatures exceeding 50 o C/ 122 o F.P280 Wear protective gloves/protective clothing/eye protection/face protection.P302 + P352 IF ON SKIN: Wash with plenty of water/…P333 + P313 If skin irritation or rash occurs: Get medical advice/attention.P501 Dispose of contents/container to … acetone; n-butyl acetate; 2-methoxy-1-methylethyl acetate; 2-hydroxyethyl methacrylate; 2,2'-ethylenedioxydiethyl dimethacrylate; methacrylic acid, monoester with propane-1,2-diol; cobalt bis(2-ethylhexanoate); dibenzoyl peroxide; benzoyl peroxide

Cramer Ceramic/Enamel Repair Kit for Baths, Sinks and Counter Cramer Ceramic/Enamel Repair Kit for Baths, Sinks and Counter

One problem is that the filler and hardener have to be mixed in a ratio of 30:1. This is very difficult to judge particularly when mixing a small amount. Some form of measure would be useful.

Can I Collect My Order Instead?

I used the product to repair a small gouge/scratch on a fiberglass bath. The damaced area is now as good as new with no sign of a repair. It took ages to decide to buy this product, after a mystery chip appeared in the new bath - it wasn't me guv! I was advised by the manufacturer to put masking tape around the damaged area before using the filler to prevent over spread and oversanding on the small repair and this worked well. This advise is not included in the instructions.

Scratch and Chip Repair Kit Alpine White - Plumbworld

The amazing thing was Ithat after two passes of spray, I could no longer make out where the chip had been! You can just detect a slight roughness but not see the repair at all..H317 May cause an allergic skin reaction.H222 Extremely flammable aerosol.H229 Pressurised container: may burst if heated.H319 Causes serious eye irritation.H336 May cause drowsiness or dizziness.H242 Heating may cause a fireH410 Very toxic to aquatic life with long lasting effects. I followed the instructions carefully and used ethyl alcohol to degrease a chip on a ceramic sink. I left the compound in place for 12 hours and then very slowly sandpapered the surface ...do not rush this bit or you can have pullout. I really took my time and then used the finest paper (supplied in the kit) which polishes the surface. The chip is virtually invisible. Needless to say I was pleased. Its a good product .but you really have to take your time.