I do find that table of joint failures fascinating - especially love the modest half lap being so strong!

It takes a bit of practice to get the jig to stay steady and drill carefully, but it's certainly cheaper than a Festool. Ten mm Dominos (the largest on the DF 500) are a bit thicker than the 5/16” dowels, so some extra strength there.All in all, this unit is fine for drilling holes and can be accurate, but is a real faff to set up, and the leaking oil is not what you want on your prized woodwork. If you're interested in cabinet making or joinery as a hobby it's absolutely fine, but not good enough for professional use. New: A brand-new, unused, unopened and undamaged item in original retail packaging (where packaging . If you prefer to make your purchase payment via online banking by bacs/chaps transfer payment , contact us to assist you. Welcome to Bradfords Building Supplies – your trusted local trade Builders Merchant since 1770, providing building supplies throughout the South West; Wiltshire, Somerset, Dorset, Devon, Cornwall and even into Hertfordshire and Worcestershire!

Da Triton von sich selbst behauptet „precision power tools“ zu bieten, ziehe ich 1 Stern ab, da man den rechten Winkel prüfen sollte, wenngleich ich auf Zentel baue und nicht auf Hundertstel. Before I bought this, I hadn't planned on mass use, but now I'm rethinking that, and I might go for the Mafell at some point. This guarantee, and the guarantee period, begins on the date of retail purchase as detailed on your sales receipt. I think dowels would be fine, but I'd personally go for half laps and then secure everything with some beefy bolts. I think the Domino is strong enough for anything I throw at it, and I make my own Dominos, so in situation like the test, if I think the loads going to be especially high I make a much wider Domino so it's more like a big floating tenon.All I can say is read the instruction, test each setting against a ruler, test the tool with some "scrap" wood, you will not find anything easier or better.

If you cannot find the item you're looking for, have a question you need answering or would like to speak to a member of the team, please do get in contact with us here today. Allerdings muss man den rechten Winkel prüfen (bei Auflage an Strinseite), dessen Einstellung nicht 100% der Skala entspricht (ca.The worst part is that the casting lines are not inline with the drill bits, and that the tool lines for dowelling seem out. Axminster Tool Centre Ltd trading as Axminster Tools is a credit broker and is Authorised and Regulated by the Financial Conduct Authority. And finally after only 3 uses, my unit has blown a seal, causing it to leak oil or grease from around the collet. Mine came with 8mm dowel drills but I believe it can also accept 5mm, 6mm, 10mm and maybe even 12mm dowel drills also.