As this in an introduction to finishing PLA, this list is non-exhaustive of the techniques you can learn to clean up your 3D prints. More tools can be used, small tips can be learned, and starting with a good model are all techniques you can use to produce finished prints, but the ones I will be going over are: Continue to progress through the grits as you need to remove less and less of your print. Once you’ve finished with 200, start using water as you sand. 400 grit and above is going to remove very little material, any major blemishes or layer lines in the model will be mostly unaffected at this point, and will more or less be polishing what you have. Repairing a car’s paintwork is a long, laborious process. That said, doing such repairs at home is possible with the right tools and supplies.

It leaves enough build on car body panels to be able to sand smooth and level before painting over it with a guide coat or top coat. The ProSpray 3.39 is the ideal device if you want to apply both airless filler and emulsion paint. It is the most powerful piston pump in the ProSpray family and is supplied with the corresponding accessories so that you are directly equipped for both application possibilities. Wear the correct personal protection equipment. A mask with a respirator is a must, especially if working indoors, and all exposed skin should be covered with gloves and long-sleeved coveralls. Time This is basically the same as the last process, except you will be using the spot putty to fill in any low spots to fill in some of the major layer lines, or rebuild minor blemishes like the top of round surface. CORROSION PREVENTIVE — our Putty Spray protects your vehicle and ensures you no longer have to worry about corrosion.

If you have some more time or working on a surface that has more imperfections than stone chips or fine scratches, then primer filler can get close to achieving a factory finish. Generally, manufacturers recommend either product be used for smaller repairs or minor surface imperfections. Painting indoors is advisable as well, if possible. Masking off areas before making any repairs is also time well spent. PPE If you have had some unfortunate scratches on your scooter that you need to have fixed, then the MoTip Spray-Putty may very well be your friend in need. The filler gives you a durable and uniform surface so you have the best conditions to get a nice and shiny varnish again. MoTip Spray-Putty is a putty in spray form that has been developed to fill in minor irregularities such as scratches and marks after sanding, so that the surface is smoothed and prepared for the subsequent varnishing. The filler can be used on both treated and untreated surfaces of wood, metal and aluminum, and the good filling properties as well as excellent adhesion make it incredibly easy to work with. MoTip Spray-Putty can be easily sanded in both wet and dry conditions and has practical rust-preventing properties.

Yes! In addition to manual spray guns for car refinishing we also provide a wide range of automatic spray guns, pumps or other accessories for the Industry usage. You can go through them by using the filtering option to select the area of application you are interested in. Pre Treatment: The surface should be clean, dry and free of grease. Remove loose old lacquer and rust and sand the surface.Although you already know, we've summarised them here again just as a reminder: Filling compounds are divided primarily into mineral fillers (such as gypsum filler) and paste-like dispersion fillers. Both products have high build potential, meaning less body panel work is required to achieve an even enough surface before applying a primer or base coat. DIY ease of use Start by sanding with 120 grit sandpaper to bring down some of the surface texture. Before adding more material on top, it’s always better to remove some material first.